The thickness of pelvic floor should reach to
After washing, the sink should be glossy, anti-oil, non-stain, anti-fouling materials and pelvic floor should be
General sink should be welded closely, no cold solder joint. Welding quality is the most critical aspect to the sink life .Welding well, it can prevent rust, Sealing-off. In the market today, any dual-slot deeper than
In addition, if the thin edge of sink is exquisite, it can fit well with the table to prevent leakage, even if there are water droplets, slag fell on the table, it can easily to be wiped into the tank with the cloth. So, pay attention to the flatness of the thin edge, because the technology requirements are relatively high, while the edge is thinner, the harder it is to achieve smooth.
